

New product
: 1 Centimeters
: 1 Centimeters
Stone
: Roman
: Late 1st ct.-2nd ct. AD
Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND)
|
Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND) Arquiberlab http://creativecommons.org/licenses/by-nc-nd/3.0/ |
|
Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND) Arquiberlab http://creativecommons.org/licenses/by-nc-nd/3.0/ |
|
Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND) Arquiberlab http://creativecommons.org/licenses/by-nc-nd/3.0/ |
IUIAI-UJA
|
Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND) Arquiberlab http://creativecommons.org/licenses/by-nc-nd/3.0/ |
|
Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND) Arquiberlab http://creativecommons.org/licenses/by-nc-nd/3.0/ |
|
Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND) Arquiberlab http://creativecommons.org/licenses/by-nc-nd/3.0/ |
University Research Center for Iberian Archaeology |
|
Raman Microscopy Mineralogical analysis Non destructive. Surface cleaning. Sample pretreatment is not required. Direct measurement. Portable Raman spectrometer (model BWS445-785S innoRam) equipped with a CCD detector, a handheld fiber-optic probe, an automated MicroBeam tripod, a benchtop stand for small samples, and a BAC151A camera (University Research Institute for Iberian Archaeology, University of Jaén). A 785 nm diode laser (300 mW) was used, with a spectral resolution better than 4.5 cm-1 |
|
X-Ray Fluorescence Elemental analysis Non destructive. Surface cleaning. Sample pretreatment is not required. Direct measurement. Olympus Vanta C portable X-ray fluorescence spectrometer with a rhodium (Rh) anode X-ray tube and a 20 mm² SDD detector. An aluminum (Al) filter was applied to measure high-Z elements (Z > 26) with a voltage of 40 kV and a current of 38.7 µA. Without Al-filter, a voltage of 10 kV and a current of 50.8 µA were used for low-Z elements (12 > Z > 26). Measurements were performed in air for 60 s. The dimensions of the X-ray beam collimator were 3 × 3 mm². |