Tessera 74. Erotes mosaic, Marroquíes Altos (Jaén, Spain)

Grey tessera belonging to the mosaic of the Erotes of Marroquíes Altos (Jaén, Spain). XRF analysis shows a high concentration of Ca, and a lower presence of Si and Al. All of this allows the identification of limestone as the raw material used in the manufacture of the tessera.
Leer más Leer menos

New product

Dimensions

: 1 Centimeters

: 1 Centimeters

Materials

Stone

Temporal

: Roman

: 2nd-4th century AD

Spatial

  • : Marroquíes Altos, Erores Mosaic
  • : Jaén, Spain
  • : WGS84
 

Copyrights

Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND)

Digital Resources

  • Tesera 74
    Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND)
    Arquiberlab
    http://creativecommons.org/licenses/by-nc-nd/3.0/
    [ver más...] [ver menos]
  • Tessera 74 in the upper right area
    Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND)
    Arquiberlab
    http://creativecommons.org/licenses/by-nc-nd/3.0/
    [ver más...] [ver menos]
  • Erotes Mosaic
    Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND)
    Arquiberlab
    http://creativecommons.org/licenses/by-nc-nd/3.0/
    [ver más...] [ver menos]
  • IUIAI-UJA
    Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND)
    Arquiberlab
    http://creativecommons.org/licenses/by-nc-nd/3.0/
    [ver más...] [ver menos]
  • IUIAI-UJA
    Creative Commons - Attribution, Non-Commercial, No Derivatives (BY-NC-ND)
    Arquiberlab
    http://creativecommons.org/licenses/by-nc-nd/3.0/
    [ver más...] [ver menos]

Activities

  • Archaeometric analysis
  • Physical-chemical analysis
  • Tessera. Composition analysis

University Research Center for Iberian Archaeology

X-Ray Fluorescence

Elemental analysis

Non destructive. Surface cleaning. Sample pretreatment is not required. Direct measurement.

Portable Olympus Innov-X Delta Premium X-ray fluorescence spectrometer equipped with a rhodium (Rh) anode X-ray tube and a 20 mm2 SDD detector. An aluminum (Al) filter was applied to measure high-Z elements (from Fe onward) using a voltage of 40 kV and a current of 38.7 µA. Without filtering (low-Z elements), a voltage of 10 kV and a current of 50.8 µA can be applied. Measurements were performed in air for 150 s. The X-ray excitation beam was collimated through a window with dimensions of 3×3 mm2

 

13 other products in the same category:

Menu